How to Install a Wood Newel Post; How to Install Iron Newel Posts; How to Bend Wooden Handrail. This guide gives general instructions so please use your own discretion as far as measurements, angles and tool choice. Here you can find step by step newel post installation tips on how to install a newel post using the L braket newel post installation. DIY Stair Installation. L Bracket Newel Post Installation Method. Install Our Staircases; Install Handrail Joints; Install Newel Caps. Changing A Newel Post; Finishing Staircases; Finishes (+ Videos) Under Stairs Cupboard; Underside of a Staircase; Useful Information. DIY Stair Installation. This is the home page of all of Morvin’s behind the scenes stair installation tips.
How To Install a Newel Post By Emily Patterson. Newel Post Installation--DIY Guide; Hammer Zone: Installing Handrail Newel Posts; Photo Credit escalier image by C
How to Install Newel Posts to Hardwood Stair Treads. How to Install Newel Posts to Hardwood Stair Treads. Newel posts are the foundation of the stair rail system and must be solidly attached to the stair tread and the framing underneath. There are many acceptable methods of attachment, but two of these methods account for the majority of installations.
The first method is to use countersunk lag bolts to attach the newel post to the stair riser. The second method is to use a newel post rod, which is the method described here. The newel post rod comes in a kit with the rod, nut, washer and a 1 1/2- inch- diameter wooden plug. Things Needed. Safety glasses or goggles. Newel post rod kit. Extra 1/2- inch nut.
Ruler. Drill. 3/8- inch drill bit. Wood glue. Hammer.
Be sure to mark the center point of each newel post’s location prior to installation to insure proper spacing. All joints, ceiling/wall interfaces.
Step 1. Mark the location for the center of the newel post on the stair tread. Make sure it's in line with your other newel posts. Step 2. Using the 3/8- inch bit, drill a pilot hole for the newel post rod. Drill to the depth of the lag bolt threads on the rod. Step 3. Thread two 1/2- inch nuts onto the newel post rod and tighten them against each other. Draw the lines from corner to corner; the center is where the lines intersect. Drill a 1/2- inch diameter hole, at least 6 inches deep, at your mark.
Step 5. Drill a hole, centered on the face of the newel post. Six inches up from the bottom, drill a 1 1/2- inch hole, 2 1/2 inches deep. This hole will intersect the hole drilled in the previous step. Step 6. Slide the newel post down over the newel post rod and install the washer and nut through the 1 1/2- inch hole. Tighten in place using the wrench. Step 7. Apply a small amount of wood glue to the edge of the wooden plug and lightly tap it into the 1 1/2- inch hole. Take care to align the plug's grain with the grain of the newel post.
Warnings. If you can't find a newel post rod, you can make your own. Cut the head off a 6- inch- long, 1/2- inch lag bolt and weld on a section of 1/2- inch all thread. Warnings. Always wear eye protection when using power tools.
DIY Newel Post Tutorial . Here's the full tutorial by sarah m.